lap joint
英 [læp dʒɔɪnt]
美 [læp dʒɔɪnt]
（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝
英英释义
noun
- joint made by overlapping two ends and joining them together
双语例句
- Influence of Elastic Modulus of Adhesive on the Stress and Strain Distribution in Aluminium Single Lap Joint
胶粘剂弹性模量对铝合金单搭接接头应力应变分布的影响 - The research is carried out with the method of orthogonal test to study the effects of some main parameters such as Poisson ratio, elastic modulus and adherend of thick on the peck value of the Von Mises equivalent stress distributed in adhesively bonded aluminium single lap joint.
运用正交试验法研究了几个主要力学和几何参数如泊松比，弹性模量和被粘物厚对单搭接接头VONMISES等效应力的影响。 - Numerical analysis on stress distribution in adhesive-welded double lap joint of aluminum
铝胶焊双搭接接头上应力分布的数值分析 - A design conception on probabilistic statistics was introduced into adhesively bonded single lap joint, and finite element method was applied to analyze the factors which have important influences on the mechanical property of adhesive joint. Using 100 samples the failure probability was concluded.
将概率统计的设计观念引入单搭接粘接接头，通过有限元分析方法分析了对粘接接头力学性能影响较大的因素，并在抽样100次的情况下，分析了单搭接粘接接头失效的概率。 - The lap joint produces bending effect under the action of tensile load and the bending degree decreases with the increase of yield limit of base material.
搭接接头在拉伸载荷作用下会产生折弯效应，折弯程度随被钎焊母材屈服极限的增加而减小。 - Finite element analysis on reliability design of adhesively bonded single lap joint
基于有限元方法的单搭接接头可靠性设计 - The elasto-plastic finite element method ( FEM) was used to investigate the effect of the elastic modulus of adhesive on the stress and strain distribution in adhesively bonded aluminium single lap joint.
利用弹塑性有限元法研究胶粘剂的弹性模量对单搭接接头应力应变分布的影响。 - Most scholars mainly adopted one dimension variation analysis model, and took qualitative analysis on the butt joint, lap joint of the parts in the research field of assembly sequence optimization which targets was dimension quality.
以装配尺寸质量为目标的装配顺序优化研究方面，多数学者主要采用一维的偏差分析模型，对零件间的对接、搭接等接头形式进行定性分析。 - Stress Analyses of Double Lap Joint by Boundary Element Method
双搭接接头应力场的边界元分析 - This paper is to discuss the interlaminar stresses of adhesive lap joint by the energy method without considering the adhesive layer.
本文以能量法求解无胶层厚度的搭接接头的层间应力。